Here are The presentation boards for submission, I think that these are a bit light in terms of information and only seem to show my development s in the second half of the project, but because everything about the first half of the project in terms of research and development is up on the blog, i thought I would submit a product and brand pitch. the physical boards are... well, shocking. I think that the type on the boards is too big, and If smaller I could have fit more information on, and it would have had that little bit more of a professional edge.
The printing of these boards was also a bit of a nightmare. I rand out of money to fund this project and had to print onto A3, this would have been fine if I could have done thi on illustrator using the page tool on the A2 documents to segment them into equal A3 documents, but I created the boards on CS4, and then tried to print them in the mac suite, shich uses CS3, this created too many problems for me to successfully manage to use illustrator properly, So I decided to open the files as PDFs in photoshop and print the two seperate sides. I actually printed off a left side, a right and a center A3 off for each board, because borderless printing is not achievable in the mac suite ( well as far as I know.) and I needed to compensate for space I would loose because of the image cropping. Then it was just a case of matching up the images so they were straight, and cropping the mountboards down to A2 by hand.
No comments:
Post a Comment